declare const sysexits: Readonly<{
    OK: 0;
    GENERAL: 1;
    /**
     * The command was used incorrectly, e.g., with the wrong number of arguments,
     * a bad flag, a bad syntax in a parameter, or whatever.
     */
    USAGE: 64;
    /**
     * The input data was incorrect in some way. This should only be used for
     * user's data and not system files.
     */
    DATAERR: 65;
    /**
     * An input file (not a system file) did not exist or was not readable.
     * This could also include errors like "No message" to a mailer
     * (if it cared to catch it).
     */
    NOINPUT: 66;
    /**
     * The user specified did not exist. This might be used for mail addresses
     * or remote logins.
     */
    NOUSER: 67;
    /**
     * The host specified did not exist. This is used in mail addresses or
     * network requests.
     */
    NOHOST: 68;
    /**
     * A service is unavailable. This can occur if a support program or file
     * does not exist. This can also be used as a catchall message when
     * something you wanted to do does not work, but you do not know why.
     */
    UNAVAILABLE: 69;
    /**
     * An internal software error has been detected. This should be limited to
     * non-operating system related errors as possible.
     */
    SOFTWARE: 70;
    /**
     * An operating system error has been detected.  This is intended to be used
     * for such things as "cannot fork", "cannot create pipe", or the like.
     * It in-cludes things like getuid returning a user that does not exist in
     * the passwd file.
     */
    OSERR: 71;
    /**
     * Some system file (e.g., /etc/passwd, /var/run/utx.active, etc.)
     * does not exist, cannot be opened, or has some sort of error
     * (e.g., syntax error).
     */
    OSFILE: 72;
    /**
     * A (user specified) output file cannot be created.
     */
    CANTCREAT: 73;
    /**
     * An error occurred while doing I/O on some file.
     */
    IOERR: 74;
    /**
     * Temporary failure, indicating something that is not really an error.
     * In sendmail, this means that a mailer (e.g.) could not create a connection,
     * and the request should be reattempted later.
     */
    TEMPFAIL: 75;
    /**
     * The remote system returned something that was "not possible" during a
     * protocol exchange.
     */
    PROTOCOL: 76;
    /**
     * You did not have sufficient permission to perform the operation. This is
     * not intended for file system problems, which should use EX_NOINPUT or
     * EX_CANTCREAT, but rather for higher level permissions.
     */
    NOPERM: 77;
    /**
     * Something was found in an un-configured or mis-configured state.
     */
    CONFIG: 78;
    CANNOT_EXEC: 126;
    COMMAND_NOT_FOUND: 127;
    INVALID_EXIT_ARG: 128;
    UNKNOWN: 255;
}>;
export default sysexits;