declare namespace openfl.display {
	/**
	 * 	Defines the values to use for specifying path-drawing commands.
	 * 
	 * 	The values in this class are used by the
	 * 	`Graphics.drawPath()` method, or stored in the
	 * 	`commands` vector of a GraphicsPath object.
	 * 
	 */
	export enum GraphicsPathCommand {
		/**
		 * 		Specifies a drawing command that draws a curve from the current drawing position
		 * 		to the x- and y-coordinates specified in the data vector, using a 2 control points.
		 * 	
		 */
		CUBIC_CURVE_TO = 6,
		/**
		 * 		Specifies a drawing command that draws a curve from the current drawing position
		 * 		to the x- and y-coordinates specified in the data vector, using a control point.
		 * 		This command produces the same effect as the `Graphics.lineTo()` method, and uses
		 * 		two points in the data vector control and anchor: (cx, cy, ax, ay).
		 * 	
		 */
		CURVE_TO = 3,
		/**
		 * 		Specifies a drawing command that draws a line from the current drawing position to
		 * 		the x- and y-coordinates specified in the data vector. This command produces the
		 * 		same effect as the `Graphics.lineTo()` method, and uses one point in the data
		 * 		vector: (x,y).
		 * 	
		 */
		LINE_TO = 2,
		/**
		 * 		Specifies a drawing command that moves the current drawing position to the x- and
		 * 		y-coordinates specified in the data vector. This command produces the same effect as
		 * 		the `Graphics.moveTo()` method, and uses one point in the data vector: (x,y).
		 * 	
		 */
		MOVE_TO = 1,
		/**
		 * 		Represents the default "do nothing" command.
		 * 	
		 */
		NO_OP = 0,
		/**
		 * 		Specifies a "line to" drawing command, but uses two sets of coordinates (four
		 * 		values) instead of one set. This command allows you to switch between "line to"
		 * 		and "curve to" commands without changing the number of data values used per command.
		 * 		This command uses two sets in the data vector: one dummy location and one (x,y)
		 * 		location.
		 * 
		 * 		The `WIDE_LINE_TO` and `WIDE_MOVE_TO` command variants consume the same number of
		 * 		parameters as does the `CURVE_TO` command.
		 * 	
		 */
		WIDE_LINE_TO = 5,
		/**
		 * 		Specifies a "move to" drawing command, but uses two sets of coordinates (four
		 * 		values) instead of one set. This command allows you to switch between "move to"
		 * 		and "curve to" commands without changing the number of data values used per
		 * 		command. This command uses two sets in the data vector: one dummy location and one
		 * 		(x,y) location.
		 * 
		 * 		The `WIDE_LINE_TO` and `WIDE_MOVE_TO` command variants consume the same number of
		 * 		parameters as does the `CURVE_TO` command.
		 * 	
		 */
		WIDE_MOVE_TO = 4,
	}
}
export default openfl.display.GraphicsPathCommand;