import { RoutingTables } from '../rule.constants';
import { RuleShowOptions } from './show.interfaces';
/**
 * Rule add options.
 * @category Interfaces
 */
export interface RuleAddOptions extends RuleShowOptions {
    /**
     * The routing table identifier to lookup if the rule selector matches.
     * It is also possible to use lookup instead of table.
     */
    table?: number | RoutingTables;
    /**
     * The routing protocol who installed the rule in question.
     * As an example when zebra installs a rule it would get RTPROT_ZEBRA as the installing protocol.
     */
    protocol?: string | number;
    /**
     * The base of the IP address block to translate (for source addresses).
     * The ADDRESS may be either the start of the block of NAT addresses (selected by NAT routes) or a local host
     * address (or even zero).
     *
     * In the last case the router does not translate the packets, but masquerades them to this address.
     * Using `map-to` instead of `nat` means the same thing.
     */
    nat?: string;
    /**
     * Realms to select if the rule matched and the routing table lookup succeeded.
     * Realm TO is only used if the route did not select any realm.
     */
    realms?: string;
    /**
     * Attribute is used to jump to a rule with a specified priority.
     * It essentially alters the typical sequence in which rules are evaluated.
     */
    goto?: number;
    /** Reject routing decisions that have a prefix length of NUMBER or less. */
    suppress_prefixlength?: number;
    /** Reject routing decisions that use a device belonging to the interface group GROUP. */
    suppress_ifgroup?: number;
}