import { OnOffToggle } from '../../../common/constants/attribute-values';
/**
 * Add link can type arguments.
 * @category Interfaces
 */
export interface AddLinkCanTypeArgs {
    /** Sets the nominal speed of the CAN bus in bits per second for the arbitration phase. */
    bitrate?: number;
    /**
     * Specifies the sampling point as a percentage.
     * It defines at which point a bit should be sampled.
     */
    'sample-point'?: number;
    /** Time Quantum. The smallest time unit for the CAN bit timing. */
    tq?: number;
    /** Propagation Segment. The time segment needed to compensate for the physical delay of the signal. */
    'prop-seg'?: number;
    /** Phase Buffer Segment 1. The first segment of the phase buffer, used to adjust the position of the sample point. */
    'phase-seg1'?: number;
    /** Phase Buffer Segment 2. The second segment of the phase buffer, also used for sample point adjustment. */
    'phase-seg2'?: number;
    /** Synchronization Jump Width. The maximum number of time quanta that the bit timing can be adjusted to compensate for oscillator drift. */
    sjw?: number;
    /**
     * Sets the nominal speed for the data phase.
     * @see {@link[bitrate]}
     */
    dbitrate?: number;
    /** @see {@link['sample-point']} */
    'dsample-point'?: number;
    /** @see {@link[tq]} */
    dtq?: number;
    /** @see {@link['prop-seg']} */
    'dprop-seg'?: number;
    /** @see {@link['phase-seg1']} */
    'dphase-seg1'?: number;
    /** @see {@link['phase-seg2']} */
    'dphase-seg2'?: number;
    /** @see {@link[sjw]} */
    dsjw?: number;
    /**
     * Enables the internal loopback mode of the CAN controller.
     * In loopback mode, the CAN controller can send and receive messages internally without the need for an actual CAN network.
     */
    loopback?: OnOffToggle;
    /** Sets the interface to listen-only mode where it will not send any messages. */
    'listen-only'?: OnOffToggle;
    /** This enables or disables triple sampling for receiving. */
    'triple-sampling'?: OnOffToggle;
    /** If enabled, this prevents the controller from automatically retrying to send a message upon an error. */
    'one-shot'?: OnOffToggle;
    /**
     * Enables bus error reporting.
     * When enabled, the CAN interface will generate error messages in the system logs if bus errors are detected.
     */
    'berr-reporting'?: OnOffToggle;
    /** Enables or disables CAN FD support. */
    fd?: OnOffToggle;
    /** Enables or disables non-ISO CAN FD support. */
    'fd-non-iso'?: OnOffToggle;
    /** Assume that the acknowledgment for a transmitted frame is received, even if it is not actually received. */
    'presume-ack'?: OnOffToggle;
    /** Sets the automatic restart delay in milliseconds if the bus is in an error state. */
    'restart-ms'?: number;
    /**
     * Enables automatic restart of the CAN controller after a bus-off condition.
     * A bus-off condition occurs when the CAN controller detects too many errors on the bus, causing it to disconnect from the network to prevent further disruptions.
     * Enabling automatic restart allows the controller to attempt to rejoin the bus after a specified delay.
     */
    restart?: boolean;
}