export interface CaptureSpecVideo {
    /** Maximum acceptable average bitrate, in megabits per second. */
    bitrate_ceiling_mbps: number;
    /** Minimum acceptable average bitrate, in megabits per second. */
    bitrate_floor_mbps: number;
    /** Recommended average bitrate to encode at, in megabits per second. */
    bitrate_target_mbps: number;
    /** Which physical lens to record with. */
    camera_lens: string;
    codecs: string[];
    /** Whether the client must also write the camera make and model into the video container's metadata. When `false`, the capture manifest and export CSV are the metadata carrier. */
    embed_camera_metadata: boolean;
    /** Target capture frame rate. */
    fps: number;
    /** Longest stall between consecutive frames a clip may contain before the client rejects it, in milliseconds. Every frame is timestamped in the frame log, so a stall stays alignable downstream — this bounds how broken a capture may be, not how evenly it must be paced. */
    frame_gap_tolerance_ms: number;
    /** Required frame height in pixels — recorded footage must match exactly. */
    height: number;
    /** Minimum acceptable horizontal field of view, in degrees. */
    min_fov_degrees: number;
    /** Device orientation to record in. */
    orientation: string;
    /** Preferred horizontal field of view, in degrees. */
    preferred_fov_degrees: number;
    /** How the client must configure video stabilization: `off` disables EIS so raw motion is preserved for pose extraction, `on` requires it, `any` leaves the device default. */
    stabilization_mode: CaptureSpecVideo.StabilizationMode;
    /** Whether hardware/software stabilization must be enabled. True exactly when stabilization_mode is `on`. */
    stabilization_required: boolean;
    /** Required frame width in pixels — recorded footage must match exactly. */
    width: number;
}
export declare namespace CaptureSpecVideo {
    /** How the client must configure video stabilization: `off` disables EIS so raw motion is preserved for pose extraction, `on` requires it, `any` leaves the device default. */
    const StabilizationMode: {
        readonly Off: "off";
        readonly On: "on";
        readonly Any: "any";
    };
    type StabilizationMode = (typeof StabilizationMode)[keyof typeof StabilizationMode];
}